| Author | Message | ||
     Andrejs2112 |
Leaving work. Turn key, kill switch on, dash lights, efi makes noise, push starter, NOTHING! no noise at all just nothing. What's the problem? | ||
| Hootowl |
Is it in gear? Check your fuses? | ||
| Andrejs2112 |
Not in gear, fuses good, 12.72 volts, terminals tight and clean, no dimming or anything when pushing button. | ||
| Andrejs2112 |
just started. dicked with the shifter in and out of gear and back to n . started up. WTF? it starts in or out of gear and you don't need the clutch pulled in to start. Strange. I no likey this. To be continued... THanks for the reply. | ||
| Barker |
neutral sensor gone wacky? | ||
| Torquemonster |
Dont stop on the way home, and pray you dont stall at a light! Good luck and ride safe! | ||
| Andrejs2112 |
My bike will start in any gear position w/o the clutch pulled in. Gear shouldn't, and hasn't made a difference. Anymore ideas? | ||
| Hexangler |
Intermittent short in ignition switch or starter button or wiring to or from them? I've had to replace one (ignition switch) on my Sportster, and one on my Moto Guzzi V50III. Just dead, with no sound. Hex | ||
| Johnnylunchbox |
Bank Angle Sensor recall done? | ||
| Twintour |
It's going to happen again, the yellow starter switch on the handle bar contol is dirty.Slip the control housing ,you can service all the switch part. sand off the brass contacts,wire eyelet, mount screw and spring. coat parts with alittle lithium grease. | ||
| Andrejs2112 |
Bank Angle Sensor recall done? The dealer said it was, but I can't see it where it should be in the tail. I need to verify. | ||
| Andrejs2112 |
It's going to happen again, the yellow starter switch on the handle bar contol is dirty.Slip the control housing ,you can service all the switch part. sand off the brass contacts,wire eyelet, mount screw and spring. coat parts with alittle lithium grease. I take it this happened to you? | ||
| Twintour |
Yes, on the way to deals gap . 250miles in, on a 550mile day. If you ride in the rain more often or wash your bike a lot. all the bar controls will become intermittent. They are not high quality control .Which is good because the start switch is a simple spring contact switch. I spray wd-40 in and around my control after washes. | ||
| Andrejs2112 |
Thanks. I ride in the rain and wash the bike a lot. I'll give it a try. | ||
| Soloyosh |
If it starts in gear without the clutch pulled in you may want to check the clutch switch. Mine refuses to start with the bars turned to the left. Currently at the dealer. They replaced the clutch switch because it was not functioning, but the starting problem still exists. I'm thinking wiring harness on mine. Cheers Brett |
