Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Horridus
| Posted on Wednesday, June 20, 2007 - 01:25 pm: |
|
Just got them in. I was looking and reading about how to install them, should I just remove the caliper or is there a better way? Thanks in advance. Horr |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Firstbatch
| Posted on Wednesday, June 20, 2007 - 01:46 pm: |
|
No need to remove the caliper all the way.. Read this link/thread below and you will be fine. I chose to pull the wheel, then take the opportunity to put anti-sieze on the axle and also you can more easily clean out the caliper and push the pucks in to accept the new pads. http://www.badweatherbikers.com/buell/messages/327 77/263485.html} |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Horridus
| Posted on Wednesday, June 20, 2007 - 02:10 pm: |
|
Very nice Firstbatch, thanks!! Horr |
|