| Author |
Message |
    
Norcalbuell
| | Posted on Friday, February 16, 2007 - 03:41 pm: | 
|
My 04 race ecm has set off codes 11 and 53 which code #53 is rom
failure of the ECM. I then inspected all wiring near the ecm and found
2 wires that got nicked from the sharp edges of the horn and had
arced. But these wires were part of the headlight wiring, I never blew
a fuse but could this damage or kill an ecm? If the ECM is indeed bad,
can it be reflashed by Al Lighton or is it shot? Also do the
functional codes mean there is still a problem with ecm or can i get
the codes cleared and see if they come back to verify if indeed the
ECM is bad.
Would it be OK to put my stock ECM in until i can get a new Race ecm?
thanks in advance
Chuck |
Brumbear
| | Posted on Friday, February 16, 2007 - 04:08 pm: |
|
You may want to try to disconect the batt wait a minute and hook it back up I do not know if the system has look look again capabilities if it does it should reset |
Reepicheep
| | Posted on Friday, February 16, 2007 - 04:23 pm: |
|
If this is a lightning, look closely (and by closely I mean just short of a microscope) at the ECM bundle that goes near your battery terminal.
I had a "micro nick" that had me throwing all sorts of bizarro codes based upon how hard I last sat down on the bike. |
Norcalbuell
| | Posted on Friday, February 16, 2007 - 04:27 pm: |
|
its a firebolt.... |
|
Troubleshooting (Poor Starting/Running/Handling/Ride Issues) »
Archive through February 28, 2007 »
Check engine Light