Author |
Message |
Jester8609
| Posted on Monday, November 13, 2006 - 10:19 pm: |
|
backing up into a pole broke off my rear signal. It was blinking rapidly whan I went to plug it back in it stopped and now neither side works! I get nothing. No dash blinker lite of any blinker. Fuse is good. ideas anyone? Jeff}}}} (Message edited by jester8609 on November 13, 2006) |
Lost_in_ohio
| Posted on Tuesday, November 14, 2006 - 07:53 am: |
|
Have you tried unplugging it again. Do you have a volt meter or a troubleshooting test lamp. |
Ezblast
| Posted on Friday, January 19, 2007 - 03:49 pm: |
|
Long story - dash cracked, so I exchanged it out with the spare I had, turned the key - dash lit up and numbers appeared. So today I go to work and the signals don't work, I blew the 15 amp system fuse - replaced - now none of my signals work - did I blow the flasher or just bad bulb? Usually if it is the bulb - the signals just flash faster - now though nothing and no sound from the flasher any more either. A little help please. Thank you. GT - JBOTDS! EZ |
Bomber
| Posted on Friday, January 19, 2007 - 06:14 pm: |
|
my bet would be flasher -- ez enough to replace, and cheap, 2! i'd also guess there's a short/ground fault somewhere, causing the problem in the first place -- using commmon troubleshooting techniques, look at the last thing you touched (almost ALWAYS works for me!) |
Ezblast
| Posted on Friday, January 19, 2007 - 06:30 pm: |
|
Thank you! |
|