Author |
Message |
Tq_freak
| Posted on Sunday, July 23, 2006 - 10:01 pm: |
|
Hey all, first I'll say that Blake I will put this is the KV also but I just wanted to get a quick answer. Last week I got a VDSTS and reset my TPS because it needed it and it worked great but i had a slight hesatation between 3 and 4 grand but it seamed to happen only under hard acceleration and in first gear, I wasnt that worried about it, but friday night I went out on it and the sky opened up on me and on the way back home I realised that the idle did not want to settle back to the 1200 range like it should but would stick at 2000 for up to a min before it would drop back down. So last night I thougth I might have screwed up the tps reset so I did it again. took it out today and the hesatation is gone, awesome, but the sticking at 2000 rpm is still there , damit. What do you all think it could be? The Air Fuel Valve setting? thank you all in advance |
Lenb
| Posted on Sunday, July 23, 2006 - 10:11 pm: |
|
From my experience your idle could be set too high. Try setting it to 1000rpm or a bit lower and perhaps reset the TPS again afterwards (I'm not sure if that's necessary though). I had the same problem and this is what the dealer did to fix it. |
Old_man
| Posted on Sunday, July 23, 2006 - 10:12 pm: |
|
Try setting the idle a little lower, 1050rpm. I had the same problem and by lowering the idle it went away. Make sure the engine is hot when setting the idle. |
Tq_freak
| Posted on Sunday, July 23, 2006 - 10:14 pm: |
|
thanx alot, I reset the idle right after the TPS reset and I really didnt give it time to warm up, I will try that tommorow. Maybe I'll reset the Tps again, run it around the block then set the idle to where is should be. that sound like a good idea? |
Ds_tiger
| Posted on Sunday, July 23, 2006 - 10:26 pm: |
|
and from my experience with this- make darn sure the throttle is complety closed and *sticking* in the throttle housing before you hit the "reset TPS" button- if in doubt-check their website or the "KV"- good luck |
Tq_freak
| Posted on Sunday, July 23, 2006 - 10:44 pm: |
|
DS_tiger. You want to make sure it is stuck? I didn't think that was go so I reset it just about stuck. I got to full stuck closed and just cracked it off of stuck before I reset it. I will make sure its stuck and try again. |
Old_man
| Posted on Sunday, July 23, 2006 - 11:08 pm: |
|
Tq_freak, Don't just drive it around the block till it warms up. Make sure its hot (fan on) when you adjust the idle. |
Brewtus
| Posted on Sunday, July 23, 2006 - 11:09 pm: |
|
WOW, thats funny! I just answered your thread in the KV, but it had a LOT less traffic! I didn't even see it here! |
Mutation_racer
| Posted on Sunday, July 23, 2006 - 11:30 pm: |
|
its your intake seals. i work for liberty hd buell if you want give us a call and ask for moose 732-381-2400 |
|