Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Rafartist
| Posted on Sunday, July 02, 2006 - 12:30 pm: |
|
I replied to a post back in the knowledge vault under the secondary drive section about a 12's chain drive conversion and thought it would refresh it back to here but it didn't and noone looks back there unless they have a question. Can someone get it to show up here again so that someone will answer my questions. Thanks. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Rafartist
| Posted on Sunday, July 02, 2006 - 12:34 pm: |
|
And is it a plain 6303 bearing or a 6303 dash something? There are multiple ones out there? |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Rafartist
| Posted on Sunday, July 02, 2006 - 12:50 pm: |
|
And after an exhaustive google search, I have come to find out that I have no idea how to tell what fits a 530 chain and has the right interior diameter to fit a 6303 bearing? To top that off, I am unsure if the bearings width will make the whole setup fit inside the stock pulley's space or can I expect to shim it on both sides. |
|