Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Dudeman
| Posted on Monday, October 17, 2005 - 09:42 pm: |
|
Folks: I'm looking for specs on the stock rear master cylinder. Anyone have info that could guide me on spec'ing a rebuild kit? Cheers! Alan 99 X1 |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Robinson_motorsports
| Posted on Sunday, June 18, 2006 - 10:16 am: |
|
I would suggest dismantling the master cylinder to measure the bore then go to NAPA. They sell replacement pistons cheap, most tend to be standard sizes, 1/2" 5/8" etc. Could be metric, I dont know for sure. They may have those too |
|