Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Tbolt_pilot
| Posted on Wednesday, June 01, 2005 - 08:14 pm: |
|
Angus and I are swapping our handlebars and I wanted to find out what to torque the handlebar clamp bolts to. I don't have a service manual so I have no idea. Thanks for any info. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Rammons
| Posted on Wednesday, June 01, 2005 - 09:06 pm: |
|
Not sure which bike you want the specs for but for an '02 X1 the front bolts are 10-12 ft-lbs (14-16Nm) and the rear bolts the same. Manual says tighten the front first then the rear. Hope this helps. Bob |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Ivershay
| Posted on Wednesday, June 01, 2005 - 10:08 pm: |
|
and it might seem like they could stand a little more - be careful not to overtighten!! |
|