| Author | Message | ||
     Buellcruiser20 |
hey wuts up everyone? nm over here started up my bike and the nut that goes on top of the bell housing inside of the primary came off and got all stripped out. how much for a new one of those nuts. i hope it isnt to costly. please responde back thanx much bye | ||
| Hoser  |
Andrew : Read this .......... http://www.badweatherbikers.com/buell/messages/3842/815 As far as how much the replacement nut cost's ?? , I'm not knowing , but be advised this can be a serious matter , as in , the splines on the sprocket shaft are easily destroyed by running with a loose engine sprocket nut !!!!. Have a close look at the threads on the crank , I've seen these wiped out too from operating the bike with the nut flailing around in there. | ||
| Buellcruiser20 |
yeah man i checked everything to see if everything is on tight and ok and everything is fine even the threads on the spindle are fine its just the bolt that got jacked up by the end of the shaft. its like i hope it isnt to expensive for that lil bolt. its like i heard some wierd noises. So i decided to open it up and looky there the bolt was laying right on the bottom of the primary cover just sitting there. but im going to see if on friday i cant just go and get a new one for cheap. thanx for all ur help and ohh yeah the link is dead it doesnt work thanx much anyways bye. | ||
| Reepicheep  |
Here is what Hoser meant... http://www.badweatherbikers.com/buell/messages/3842/81504.html |
