Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Roderick
| Posted on Thursday, July 23, 2020 - 04:32 pm: |
|
Are there any major differences between the S1 and S2 regarding the main wiring harness? Routing, connectors, etc... Thanks. Roderick |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Kc_zombie
| Posted on Thursday, July 23, 2020 - 05:10 pm: |
|
Yes, lots. I have never tried to use one on an S1, but I do not believe they are compatible. IMHO, if you can't locate an S1 harness then a pre-fuelie S3 harness will work better. At least it did for me on a S1W restore. A few extra leads but much closer than the S2. Good Luck |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Upthemaiden
| Posted on Thursday, July 23, 2020 - 07:42 pm: |
|
Even better would be an M2 harness, if you can find one |
|