| Author | Message | ||
     Greg_m |
Was thinking of ordering Barnett #306-30-20015 but the vendor's software generated an error saying it doesn't fit the bike. Have I got the part number wrong? Thanks, | ||
| Dtaylor |
You've got the right part number, Greg. I installed that same one on my 2008 Uly this spring. Ordered it from Fortnine: https://fortnine.ca/en/barnett-clutch-plate-kit-306-30-20015 (Message edited by dtaylor on September 18, 2018) | ||
| Greg_m |
Thanks Doug! | ||
| Steveford |
I put a Barnett in my 06 this past Spring with good results so far. | ||
| Greg_m |
Ordered. Thanks all. Greg | ||
| Ourdee |
Greg, Please, post pics of it going in and any tips you gain knowledge of. | ||
| Greg_m |
Will do. Likely a winter project though. | ||
| Dtaylor |
Hey Greg, did you manage to gather all the pieces for the XB9 primary, and will that be part of the winter project? | ||
| Greg_m |
Exactly right Doug. Got everything I need to do some major maintenance. 3 bearing wheel too. I've asked about a 3 phase stator in another thread in case that's also an option while I'm in there anyway. | ||
| Ourdee |
Greg, Might call Roadster Cycles and see is they have one. I thought they used to sell a three phase stator. Not sure though. | ||
| Greg_m |
Ourdee, I emailed Jack and he suggested I find a Cycle Electric CE-6014. Pictures of the CE-6014 I can find show only two wires so it wouldn't be 3 phase. And it's listed as a direct replacement for my bike which is single phase (two phase). So... I'm looking for other options. Other years/models had 3 phase but I don't know what would fit or if the rotor would need swapping as well. | ||
| Motorfish |
I got a 3 phase stator from Cycle Electric last year. Try contacting them. I’ve read on this site that the Accel #152111 also works, with modifications to the plug. http://www.badweatherbikers.com/buell/messages/142 838/720806.html | ||
| Greg_m |
Thanks for chiming in Motorfish.Any idea what part numbers were involved on your bike? I'm hoping to use rotor # 30018-08, part of an XB9 primary conversion. | ||
| Motorfish |
I believe I have the CE-6014 stator. I have an 08 crank but I’m pretty sure I have the 06 rotor. I don’t remember having to get an 08. I think the rotors are the same between those years. Others here can confirm that. I know that the stator is 3 phase and the Shindengen VR works with single(2 wire) or 3 (3wire) phase stators. I don’t know about the XB9 primary conversion, but there’s a lot of information and folks here who know about it. | ||
| Motorfish |
Looking in my Buell parts book, the rotor with sprocket for 06 is part number 32494-04, so I must have the 08-10 rotor. I had the Dark Horse 08 crank put in, which obviously has the 08 rotor. Hope this helps. | ||
| Greg_m |
That's a huge help. Thanks. Once I get this sorted I'll take some photos and post the part numbers for anyone else going down this path. |
