Author |
Message |
Nickbatroneygmailcom
| Posted on Thursday, April 13, 2017 - 07:34 pm: |
|
09 1125cr idle surges and eventually stalls runs fine off idle jumped diag wires 1 and 2 and light does not flash i have seen engine light on just before stalling any ideas |
Gabby_duck
| Posted on Saturday, April 15, 2017 - 07:20 am: |
|
1) Clean out Iac port 2) Reset TPS 3) Intake seals leaking? 4) make sure battery conections are tight |
Nickbatroneygmailcom
| Posted on Saturday, April 15, 2017 - 08:01 am: |
|
This started after battery died over winter installed new battery bike ran fine before storage |
Gabby_duck
| Posted on Saturday, April 15, 2017 - 08:14 am: |
|
Reset AFV also make sure that battery is fully charged after storage. |
Gabby_duck
| Posted on Saturday, April 15, 2017 - 08:16 am: |
|
Fresh fuel |
Gabby_duck
| Posted on Saturday, April 15, 2017 - 08:19 am: |
|
Is the stator/voltage regulator good |
Nickbatroneygmailcom
| Posted on Saturday, April 15, 2017 - 09:43 am: |
|
Put full tank of gas ran down highway for 20 minutes battery is charged voltage is 13.9 just off idle... afv? |
Gabby_duck
| Posted on Saturday, April 15, 2017 - 11:50 am: |
|
Did you do the tps reset |
Gabby_duck
| Posted on Saturday, April 15, 2017 - 11:52 am: |
|
Did you clean IAC (idle air controller port) |
Nickbatroneygmailcom
| Posted on Saturday, April 15, 2017 - 01:33 pm: |
|
Tried tps reset manually dont have a diag machine didnt make da difference as longbass im doing it right took throtle bodies off cleaned iac checked for vacuum leaks also |
Gabby_duck
| Posted on Saturday, April 15, 2017 - 03:57 pm: |
|
Power switch to on then turn key to on Take throttle all the way open wait one second let go of throttle allow to snap back to close. Do this 3 times then turn key off and back on. Crank and allow to idle for about 10 minutes to learn idle curves.[ Of course throttle snap is done with engine off but power on] |
Nickbatroneygmailcom
| Posted on Saturday, April 15, 2017 - 04:20 pm: |
|
Ordered buelltooth today gonna do a reset and remap ecm |
Gabby_duck
| Posted on Saturday, April 15, 2017 - 04:41 pm: |
|
Make sure you save your original map,down load ECM droid free for non apple devices |
Gabby_duck
| Posted on Saturday, April 15, 2017 - 06:54 pm: |
|
Clean all grounds |
Nickbatroneygmailcom
| Posted on Sunday, April 16, 2017 - 10:28 am: |
|
I saw a video on YouTube and the guy set tps to 5 it doesnt seem right but im a auto mechanic not a motorcycle mechanic |
Gabby_duck
| Posted on Sunday, April 16, 2017 - 10:42 am: |
|
You dont do that with o9 |
Gabby_duck
| Posted on Sunday, April 16, 2017 - 10:43 am: |
|
I gave you the instructions above |
Gabby_duck
| Posted on Sunday, April 16, 2017 - 11:05 am: |
|
https://youtu.be/n2F4m2rppPA |