| Author | Message | ||
     Phelan |
WesTek Billet Clip Ons, with billet 1"-7/8" stepped handlebars and 1" chrome handlebars. S2T height, but much more adjustment available than factory S2T bars due to the dual pivot points. I ran these on my S2T with 7/8" handlebar controls. These will fit all tubers with factory USD forks if you push your tubes up ~2" in the trees, or better yet use the more adjustable WP ROMA forks from the S2s as they are 2" taller than S1/X1/S3 forks due to the clip ons. $130+shipping.  | ||
| S1owner |
Would these fot XB forks 54mm? | ||
| Phelan |
Yes, as long as you have ~2" sticking out the top. If you are using 03-04 XB forks in tuber triples these are your huckleberry  . | ||
| S1owner |
Great well I am calling dibs on them but you have to give me a 5 days or so to figure out $$ its house payment week! | ||
| S1owner |
Have small ones on my build and I just dont think I can ride like that! | ||
| Phelan |
That sounds fair to me Ken  . | ||
| Johnod |
Email sent | ||
| S1owner |
Will get payment to you soon | ||
| S1owner |
Ross one question on the 7/8" area is there room for 7/8 master and clutch perch also? | ||
| Phelan |
Yep  I should note that one of the stepped bars is slightly shorter in length- use that one on the throttle side, as the throttle will hang off slightly to make up the difference. (Message edited by phelan on July 02, 2015) | ||
| Joplin |
sold? | ||
| S1owner |
These are sold but the 1" bars alone are up for sale | ||
| Phelan |
Ken, you should take some measurements for Marc and see if he'll make a few sets. The bars are somewhat useless without the clamps, since stock S2 bars have the clamps welded to the stock bars. Those bars were cut out of a set of Harley Buckhorns and would be easy enough to replicate if you have clamps for them. |
