Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
2stang
| Posted on Thursday, March 26, 2015 - 12:28 pm: |
|
Anybody know it? Can't find it in service manual. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Stevel
| Posted on Thursday, March 26, 2015 - 01:47 pm: |
|
I have it, but I am not sure what exactly you want. If you are looking for rod bearing shells, I have a story to tell, so you should hear it before you reinvent the wheel. The info you need is only found in the design and manufacturing drawings by ROTAX. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
2stang
| Posted on Thursday, March 26, 2015 - 02:02 pm: |
|
SteveL - Yes, I need the hosing bore size of the big end. I upgraded to the ARP bolts and want make sure it doesn't distort the housing bore. (Message edited by 2stang on March 26, 2015) |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
2stang
| Posted on Thursday, March 26, 2015 - 02:10 pm: |
|
Any specs you have for the crank and rods, I would be very appreciative if you could pass those on. Thanks |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Stevel
| Posted on Thursday, March 26, 2015 - 02:29 pm: |
|
The standard con rod bore torqued is 1.7715" or 44.99mm. You should have the stretch spec from ARP to tighten the bolts, not the factory torque number of the factory screws. You should expect about a .006" bolt stretch when in tension over un-tensioned, but get the spec from ARP, then translate that to the exact required torque with YOUR torque wrench. |
|