Author |
Message |
Mhlunsford
| Posted on Sunday, August 10, 2014 - 12:42 am: |
|
I had the cams out put back in it ran for a few blocks now the ignition rotor is not turning? |
Mhlunsford
| Posted on Sunday, August 10, 2014 - 01:20 am: |
|
Just check pistons are moving |
Littlebuggles
| Posted on Sunday, August 10, 2014 - 03:06 am: |
|
Double checked alignment marks prior to putting it all together? Didja get the hardware tight? Cause I'd suspect the screw is loose, or something of the sort. |
Littlebuggles
| Posted on Sunday, August 10, 2014 - 03:17 am: |
|
There's a locking pin on the cam side of the crank - output shaft where you put the bronze oil pump drive gear - that likes to shear off sometimes too. |
|