| Author | Message | ||
     Shadowracerx1 |
I have a micron exhaust that did not come with the chin fairing support. I've purchased one from Dean but now I need to figure out what nuts/bolts are needed to actually use it on the bike. Any help would be greatly appreciated. Thank you. | ||
| D_adams |
   Wish I had known it was for a micron, it may not fit, although it fits pretty much everything else out there. Give me a call or shoot me an email. | ||
| Brother_in_buells |
I haven't installed the micron i have ,but this is what i got. 1- 159/181 dia band clamp 1- 2hole tapped bar 1- 3hole tapped bar 7- M6 x 20 button head screw 1- M8 x 50 cap head 4- M8 x 12 hex head screw 9- M6 washer 4- M8 washer 2- M8 repair washer 2- M6 nylock 1- M8 nylock 2- cable ties  | ||
| Ducbsa |
Maybe bolt the straps to the fairing while it is off the bike to see where it fits and how it would tie into however it mounts to the bike? | ||
| Shadowracerx1 |
Thank you. | ||
| D_adams |
Confirmed fit for guys with a micron exhaust and missing the brackets. Muffler needs to be removed to install the kickstand side bracket.     |
