| Author |
Message |
    
Court
| | Posted on Saturday, October 11, 2008 - 12:03 pm: | 
|
Just did the FatVM . .. nice. I stuck about 4 more things on Henrik's bike today . . gotta know what's going on.
FtB. . . thanks for blazing the trail.
I'm curious to see who, at Buell, has the tiny finger to put the small nut, nearest the steering pivot, on.
I used a long extension magnet and some language I learned in the service.
I wanted to put silicon around the wires into the housing to seal them and didn't have any around. I cut a sponge type earplug in half, compressed it and stuffed it in the hole.
Great work FtB.
Court |
Reepicheep
| | Posted on Saturday, October 11, 2008 - 12:32 pm: |
|
Ben and I mocked up your relay delay (rev 2) on the breadboard last night. Appears to be working well, but I want to add some hysteresis so if it drops out it waits a few seconds to cut back in. |
Court
| | Posted on Saturday, October 11, 2008 - 02:53 pm: |
|
FtB . . . where did you connect the voltage monitor?
Bill: Henrik will be using this bike a lot so make it as perfect and as hysterical as possible.
I tossed the PIAA wiring harnesses and made my own . . . damned impressive I might say! |
Nillaice
| | Posted on Wednesday, March 20, 2013 - 10:33 pm: |
|
(Message edited by nillaice on March 21, 2013) |
Nillaice
| | Posted on Thursday, March 21, 2013 - 05:08 pm: |
|
yes, i'm posting in a thread that has been in a coma for the last 5 years. but this thread is friggin great an is very searchable. it seems to be the origional thread that others will refernce, so maybe my post will help some body out.
i ordered mine from ebay. signal dynamics still has them on thier site, but they charge a few bucks for shipping. i followed Ft B's pic-strucions and only have some enhancements to contribute.
~ stick the box about an half inch from the port on the back of the IC, not right next to it as pictured. i had some interference with the conrtoll switch wiring.
~ you can take the IC out of the module with the bottom gromet and nut still attached. that 5/16 nut is hard to reach, but IS doable with a magnet and 'words of encouregement' as previosly mentioned.
other than that i soldered the wires into the back of the plug for the 12v outlet. red to red, black to black and yellow.
pretty slick, i know.
of course i had to re-solder it cuz the wires need to be routed and soldered with everything installed 
it looks fatory-esque .... and nobody will ever see it |
Froggy
| | Posted on Thursday, March 21, 2013 - 05:14 pm: |
|
 |
|
