| Author |
Message |
    
Porkchop1978
| | Posted on Monday, February 25, 2013 - 09:51 pm: | 
|
I have installed a new erik buell ecm and kn air filter and a drummer ss pipe this bike was fouling plugs befor and still doing it I need some help/ by the way its not showing a thing on the computer. |
Kevmean
| | Posted on Tuesday, February 26, 2013 - 06:07 pm: |
|
Do you always make sure that if you start the bike you run it up to full temperature? ........... if you start them during the winter just for a few minutes they will foul plugs. |
Porkchop1978
| | Posted on Tuesday, February 26, 2013 - 10:51 pm: |
|
yes this bike done this when it was warm aswell |
Porkchop1978
| | Posted on Sunday, March 03, 2013 - 11:22 pm: |
|
Ok friends pls give me some feed back. I changed out mt temp sensor and my coil and wires aswell as a new O2 sensor. This bike gas got a little better plugs are not wet now but bike still idoling from 900 too about 1200 this bike does have a new erik buell ecm. Does any one think I could maybr have a bad ecm the bike has had a tps reset. |
Froggy
| | Posted on Tuesday, March 05, 2013 - 10:07 pm: |
|
The recommend idle spec is 1050-1100rpm, so that sounds right. If you must, adjust the idle screw a tad to raise it. |
Porkchop1978
| | Posted on Friday, March 08, 2013 - 04:40 am: |
|
Froggy thanks for input much needed i havent got much help on here so thank you. I found that my ecm from ebr was no goof reinstalled stock ecm and bike ran much better. I guess now i need a exhaust valve block off plug? And tps reset reset what do you think? My cooling fan doesnt kick till around 320 is that seem right? And again friends thanks iam new to the buells i love my bike theres no better sport nike but need a little tech help. |
Troubleshooting (Poor Starting/Running/Handling/Ride Issues) »
Archive through August 17, 2013 »
07 xb12r fouling plugs