G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile

Author Message   01x1buell Posted on Friday, August 17, 2012 - 04:48 pm:        What do i have to do to test this??   Wack01 Posted on Friday, August 17, 2012 - 04:59 pm:        You can check if it functioning with a voltmeter, but it will only tell you if it sending a signal.   01x1buell Posted on Friday, August 17, 2012 - 05:02 pm:        well how and what am i looking for on the voltmeter   Buellistic Posted on Friday, August 17, 2012 - 05:51 pm:        FLUXUATION/FLUXUATIONS from ZERO to PLUS 5 VOLTS !!!   01x1buell Posted on Friday, August 17, 2012 - 06:02 pm:        ok i hear what you two are saying, but can i get some instructions on what to do and where to hook up the voltmeter?? please   Buellistic Posted on Friday, August 17, 2012 - 08:12 pm:        Get your engine at operating temperature ... Unplug the 02 sensor wire ... El Cheap O digital multimeter and set on what ever setting gets you to the 5 volt scale(buy at HARBOR FREIGHT) ... Take one alligator clip on one meter lead and clip it on the head and the other clip to the 02 sensor wire ... As you moe from idle to just above idle the voltage will fluxuate ... You have to under stand for the 02 sensor to work properly the right the rear header gasket has to be good ... IF THIS GASKET IS NOT GOOD THE 02 SENSOR WILL NOT WORK CORRECTLY NO MATTER HOW MANY NEW 02 SENSORS IS PUT IN WHICH IS WHY H-D technicians HAVE SO MUCH TROUBLE WITH SWAPPING 02 SENSORS WHICH DO NOT WORK !!!   01x1buell Posted on Friday, August 17, 2012 - 08:40 pm:        Lafyette thank you i will do that tomorrow.

Add Your Message Here Post: -Color- Black Red Green Blue Yellow Purple Orange Cyan Gray White -Font- Arial Courier Symbol Times Verdana -Size- Smallest (-2) Small (-1) Normal Large (+1) Largest (+2) Username: Posting Information: This is a private posting area. Only registered users and custodians may post messages here. Password: Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.) Enable HTML code in message Automatically activate URLs in message Action: