Author |
Message |
Norcalsaint
| Posted on Saturday, March 10, 2012 - 10:37 pm: |
|
I spent some time in the garage today... - New plugs/wires - Oil/Filter change - Transmission oil changed - Replaced my dented headers with a used set - Moved my intake temp sensor back to where it should be - Installed a Jaz breather catch can.
|
Preybird1
| Posted on Saturday, March 10, 2012 - 11:11 pm: |
|
Nice! But i would move those steel braided lines away from the frame they are going to rub into the frame in 5 minutes. What is that breather going to? |
Preybird1
| Posted on Saturday, March 10, 2012 - 11:15 pm: |
|
You should swap out your fuel filter for a nice billet re-usable one like this one! http://www.amazon.com/Mr-Gasket-6162G-Billet-Filte r/dp/B000BRES5A The link is just for reference, I have seen these filters around $25-39 |
Gmaan03
| Posted on Saturday, March 10, 2012 - 11:20 pm: |
|
Or you could of put this one on, billet brass and aluminium
|
Norcalsaint
| Posted on Saturday, March 10, 2012 - 11:27 pm: |
|
Nice! But i would move those steel braided lines away from the frame they are going to rub into the frame in 5 minutes. What is that breather going to? I have an orange zip tie right where it touches the frame. I am hoping it bounces off that w/out rubbing to much. If it does not work I will come up with something else... One breather line from the heads and the other from the transmission. |
Norcalsaint
| Posted on Saturday, March 10, 2012 - 11:28 pm: |
|
BTW I agree on replacing the filter, just have not bought one yet. |
Kilroy
| Posted on Sunday, March 11, 2012 - 06:17 am: |
|
Run the breather from the heads between the cylinders. Try to get it to slope continuously from the breather down to the catch can or else you will have a trap in the line. Kilroy |