Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Oldog
| Posted on Monday, January 16, 2012 - 04:59 pm: |
|
can some one look up some part#'s for the X1 fuel injector orings both ends I also need a gasketed washer its a harley part some sort of drain seal it fits on a 1/2" bolt ( breather bolt ) I have the intake off replacing the seals and need the orings and lost the bag the gasket washers came in..... ALSO the woven exhaust port gaskets.. TIA |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Jramsey
| Posted on Monday, January 16, 2012 - 05:30 pm: |
|
Here ya go buddy. Ex gasket #17048-98 O-ring in #27337-99Y O-ring out#27338-99Y Breather gasket is a no show in the parts book. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Oldog
| Posted on Tuesday, January 17, 2012 - 05:21 pm: |
|
revised nummers p0028.02a8 injector oring p0029.02a8 injector oring one is upper one is lower, I am not sure which is which the magic gasket If you run banjo bolts you want to try these 26231-78 oil pump assembly washers used on the shovel head & pan head motors HD parts fiber & steel washer seal the intake mounts and banjos oil tite ... |
|