Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Jcjohnson33
| Posted on Monday, December 19, 2011 - 11:15 pm: |
|
Anyone have a few picks on how the throttle cables route around the ignition switch? Mine are not correct and want them better routed than I have them now. And it's an R |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Nm5150
| Posted on Monday, December 19, 2011 - 11:28 pm: |
|
I don't have a pic but after mounting a steering damper mine would catch a little so I just put a zip tie around everything and didn't pull it all the way tight and it keeps them from snagging on anything when I turn the barsHTH |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Zac4mac
| Posted on Tuesday, December 20, 2011 - 02:00 am: |
|
![](http://www.badweatherbikers.com/buell/messages/290431/662279.jpg)
![](http://www.badweatherbikers.com/buell/messages/290431/662280.jpg) Here's a couple also showing where I removed material from the fairing stay. Pressure from the stays caused a couple of connections on the keyswitch to fail. No problems since. Z |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Jcjohnson33
| Posted on Tuesday, December 20, 2011 - 02:11 am: |
|
Thanks zac that's what I was looking for. I need to trim my stay a little bit to. I have not had any problems but better safe than sorry |
|