| Author | Message | ||
     Torquaholic |
As some of you may remember, I rear-ended a car on the highway this July and parted out much of the bike in the following months. Things have worked out well and I am now fully recovered. I finished engine disassembly recently and am able to post up the remaining parts for sale. Just to clarify for those who didn't know, the bike's damage was all in the front. The forks were trashed and the front neck was crushed. The motor ran fine after the wreck. After I was tossed off, the bike did end up laying down on the right side, which rashed up the right side header and clutch cover, and ripped the right rearset right out of the right engine case. Here's some of the more major parts I've still got lying around: *2008 1125R factory ECM with the Ohio company's PFU flash installed for open exhaust, all software and data cable included in the setup. $60 shipped http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070049.jpg * 2009 1125R swingarm, painted graphite grey over the factory black powder coat. $80 plus shipping * 2008 1125R rear shock $20 plus shipping http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070041.jpg http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070040.jpg http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070039.jpg *2008 1125R subframe. $50 plus shipping sale pending to Timebandit http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070037.jpg http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070036.jpg http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070034.jpg http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070038.jpg *1125R rear sprocket $50 plus shipping and front compensated sprocket $50 plus shipping, or $80 plus shipping if you buy both together. sale pending to Jdugger http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070047.jpg http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070058.jpg *1125R factory muffler turn-outs by APH, brand new and never installed. $40 shipped http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070048.jpg sale pending to Ridenusa41 *2008 1125R clutch basket, springs, plates $40 shipped sale pending to Jdugger http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070056.jpg *2008 1125R fuel pump. sold!, Thanks Zac4Mac! *2008 1125R engine parts, various parts available. Transmission gears, crank/rods/pistons, cylinders, left side engine case, timing chains, throttle bodies, etc... Contact me if you're interested in a part. I'll check availability and we can talk prices and shipping. I have no use for these parts, so any reasonable offer will be considered. EDIT: intake track/heads/cams/valve covers, Stator/Rotor/charging system,all body plastics, wheels and tires,belt and brakes have been sold. http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070053.jpg http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070054.jpg http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070055.jpg http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070057.jpg http://i196.photobucket.com/albums/aa243/foxbodynu t89/parts%20for%20sale/P1070042.jpg Thanks to all in BadWeb who have bought parts from me since the wreck. You all have helped tremendously and I can't say how much I appreciate it. -Kevin Seery College Station, TX. (Message edited by torquaholic on December 18, 2011) (Message edited by torquaholic on December 18, 2011) | ||
| Zac4mac |
PM sent on fuel pump | ||
| Jdugger |
I want the sprockets... Pm me w your address and ill send payment. | ||
| Jdugger |
Ill prob take that clutch, too | ||
| Torquaholic |
Jim, PM on its way. -Kevin | ||
| Curve__carver |
08 stator? | ||
| Timebandit |
Interested in the rear subframe if the 2008 and 2009 are the same part. Have you got a part number for that 2008 Rear Subframe? 2009 part number is L0090.1AM. | ||
| Torquaholic |
stator/ charging system was sold earlier. Sorry Curve Carver. Timebandit: I believe the subframe is the same for all three years of 1125R and CR. All I have on the subframe is a serial number that's stamped into the cross tube nearest the brake light. | ||
| Nillaice |
i might could use a crank, and water pump. ... which rev/part # water pump do you have? | ||
| Timebandit |
REAR SUBFRAME. I've confirmed with another forum member that the part numbers in the 2008/09 parts manuals are the same. You've got a PM. thanks. | ||
| Ridenusa4l |
dibs on the turnouts! Jake | ||
| Avalaugh |
Is the belt available please ? | ||
| Zac4mac |
Kevin - Addy and payment are there now. Thanks!! Z | ||
| Torquaholic |
*Timebandit, look for a detailed email on subframe today. *Ridenusa41, email sent on turnouts. *Nillaice, water pump is factory version from 2008. Never had any issues. The bike had a little under 10,000 miles. I'll try to locate the water pump today and get back to you about any numbers I see on it. Thanks. *Zac4mac, Thanks! will get fuel pump shipped ASAP. *Avalaugh, I'm sorry but the belt was sold shortly after the wreck. Thanks for asking though. :-) | ||
| Gofast |
I want the shock. Send me your address and I'll send payment. Shipping zipcode is 75070 McKinney TX Do you have the rear header for 2009 1125R? I'm getting mine ceramic coated and would like to coat a set and just swap them out when I do the valve check. | ||
| Puzzled |
PM sent. | ||
| Torquaholic |
Puzzled, PM replied to about engine case and cylinders. Gofast, PM sent with my address. I'll hold the shock for you. Can't go back and edit the post now that it is a few days old. Turnouts paid for and mailed to Ridenusa41 this evening. Thanks! Thanks, BadWeb!! (Message edited by torquaholic on December 19, 2011) | ||
| Torquaholic |
...shock sold and shipped to Gofast. Thanks! Nillaice, If you're still interested, I've separated the crank from rods and pistons. The water pump didn't have any obvious markings. The pump cover and pump are still attached to the engine case piece. Please let me know if you're still interested in them. Thanks! Swingarm, ECU, Crank, rods, pistons, cylinders, left engine case, throttle bodies, kickstand, like-new factory 1125R seat, radiator fans, and some dinged up '08 headers are still available for anyone who wants them. Thanks, BadWeb! You are all so awesome. -Kevin (nack_nack@hotmail.com) | ||
| Punisher1125r |
Pardon my ignorance but does that ecu do anything for power or is it pretty much the same as stock?  | ||
| C818919 |
Im looking for the engine clutch cover?? I read deeper saw it was damaged. Thanks. (Message edited by c818919 on December 23, 2011) | ||
| Torquaholic |
Punisher1125r, That ECU has a static performance tune for open exhausts installed on it. Static in that it does not use the oxygen sensors to adjust fueling. It was reverse engineered and developed by someone before Buell closed down and the EBR ECM's were available. The exhaust it was developed on was the Jardine slip on. I have read that it worked well on other open exhausts. There is also a program included that allows for adjustments to the map to be made. I was never confident enough to fiddle with that and only adjusted the AFV until it felt right. If you search for Ohio and Sport and Bike all together, you might find a lot of info on this or other Buell websites. BadWeb moderators do not support the discussion of it openly, so that's all I can say.} |
