Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Texas_firebolt
| Posted on Saturday, February 05, 2011 - 02:51 pm: |
|
Downloaded EcmSpy and installed the driver. When i have everything ready, with the ignition switch on and the run/stop button on run, i hit connect. It pulls up COM3 and when i hit ok it doesnt do anything. If i go to autodetect it will say "got COM port" but nothing happens. I dont get any readings on anything. Im stumped and not that computer savvy so please someone help me!! |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Texas_firebolt
| Posted on Saturday, February 05, 2011 - 03:28 pm: |
|
It worked briefly, then in the middle of a TPS reset, it froze. The numbers were there but they didnt change when i turned the throttle, etc... I tried reconnecting and it wont do anything now(again). This is frustrating me to no end... |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Terrys1980
| Posted on Saturday, February 05, 2011 - 11:25 pm: |
|
When you do a tps reset it does disconnect. The COM port might be stuck open, try restarting the computer. |
|