Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Billybob
| Posted on Friday, March 26, 2010 - 12:05 am: |
|
is there a special socket for changing the oil press sending unit? i have a 12point 1 inch that wants to slip thanks |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Tbolt_pilot
| Posted on Friday, March 26, 2010 - 01:54 am: |
|
I just did mine. I'm sure there is a socket of some number of points and size that will go over it and not slip. I ended up using a robo-grip (or channel locks) to remove the old one. Hand threaded the new one til I couldn't turn it then carefully used the robogrip with a little tape over the jaws. There should be threadlock or sealer already on the new unit. No leaks so far. Of course, my chin fairing is off so I had more room to maneuver. Good luck, be patient. |
|