Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Blackbear
| Posted on Saturday, February 20, 2010 - 10:10 pm: |
|
Anyone know if the new EBR ECM Y0152.10AZ over rides the de-noid proceedure? (unplugging connector & plugging in the resistor) Its been one week since I ordered the new ECM and it should be in this coming week. Can't wait as the 1125r runs pretty rough below 3500rpm |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Ridenusa4l
| Posted on Sunday, February 21, 2010 - 04:55 am: |
|
yes it does, but id email EBR just to make sure Jake |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Morpheuz
| Posted on Sunday, February 21, 2010 - 06:24 am: |
|
yes it does. i emailed EBR on that soon after receiving my PUMP GAS ECM and they said yes! ------------------------------- From: Info at Erik Buell Racing [mailto:info@erikbuellracing.com] Sent: 16 febbraio 2010 16.56 To: Troia, Stefano Subject: RE: Order 1379 - RACE ECM INFO It does disable the solenoid, so the resistor plug is not needed. Customer Support Erik Buell Racing From: stefano.troia@accenture.com [mailto:stefano.troia@accenture.com] Sent: Tuesday, February 16, 2010 9:17 AM To: info@erikbuellracing.com Subject: Order 1379 - RACE ECM INFO Hi, I’ve just received my PUMP GAS ECM module. Just a question: is it true or not that this ECM disable the “denoid”? I’ve bought the resistor plug (Y0248.1AM) to by pass it, do I need to install this part or not? Thanks. Regards. ------------------------------- (Message edited by MorpheuZ on February 21, 2010) |
|