Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Kalali
| Posted on Tuesday, December 15, 2009 - 12:31 pm: |
|
Can the LED blinkers be mixed with the OEM, e.g, LED in the rear and the OEM in the front? Question applies to both scenarios: with and without using the upgraded flasher relay to correct the blinking rate. Thanks. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Al_lighton
| Posted on Wednesday, December 16, 2009 - 09:41 am: |
|
not a problem..but since they are wired in parallel, you'll probably get fast flash rate with LEDs at either end, and no flash with LEDs at both ends, if you don't have a suitable flasher or resistor mods. Al |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Kalali
| Posted on Thursday, December 17, 2009 - 01:25 pm: |
|
Thanks Al. So what will the relay do to the flashing rate of the non-LED set if I use LED in front and stockers in the back? And how much faster is the blinking rate if I use LED just on one end w/o the relay? Twice as fast as the stockers? |
|