Author |
Message |
Yo_muda
| Posted on Saturday, September 19, 2009 - 08:34 pm: |
|
I replaced my plugs on my 02 M2, and I pulled out Champion RA8HC. If Im not misstaken I think these were for a Blast. Wondering what this could have done to the engine? |
Buell_bert
| Posted on Sunday, September 20, 2009 - 12:10 am: |
|
Kinda like to late to worry but I doubt it is to bad. Just install the proper ones. I show 10R12 or DPR9EA. |
Coldhands
| Posted on Tuesday, September 29, 2009 - 09:31 pm: |
|
I think the correct plug is NGK DCPR7E. That's what I use in my M2.} |
Coldhands
| Posted on Thursday, December 10, 2009 - 10:10 pm: |
|
I got that wrong, It should be NGK DCPR9E |
Buell_bert
| Posted on Friday, December 11, 2009 - 02:45 am: |
|
Look under Knowledge Vault/Engine/Electrical(Plugs). Near the upper end it says NGK DPR9EA-9 which is equal to 10R12. Good luck. Update: The NGK site says DCPR8E but else where here they say would be a little to warm. (Message edited by Buell_Bert on December 11, 2009) |
Coldhands
| Posted on Friday, December 11, 2009 - 08:30 am: |
|
bert, Thanks for that info. Des |
Daveswan
| Posted on Friday, December 11, 2009 - 11:20 am: |
|
I put in the DCPR8E's and yeah, they are a little too warm. I just pulled them and switched to the 9's. |
|