Author |
Message |
Adsva83
| Posted on Saturday, November 07, 2009 - 11:36 am: |
|
I've been trying to get the rear rotor off of my wheel on the X1 and the bolts absolutely will not budge. I've stripped one bolt and snapped two hex sockets off in them. What's next, should I just drill them out? I'm frustrated enough with it that I have thought about just buying a new rear rim. |
Adsva83
| Posted on Saturday, November 07, 2009 - 11:50 am: |
|
Those bolts aren't reverse threaded are they? I'm guessing no since they are not on a rotating shaft, but that's my only guess as to why they won't move. |
Onebadx1
| Posted on Saturday, November 07, 2009 - 11:53 am: |
|
I've had probs in the past with the same issue. I took heat to them them used a manual impact driver. I also stripped mine. I ended up using a sharp center punch on the flat part of the bolt and working it out that way. I have also went with the next size bigger hex and pounded the crap out of it to force it in the stripped hole. With heat...I got mine out. If you do end up drilling, you could always re tap. If you don't have the tools, bring the rim to a machine shop. Still cheaper than buying a new rim. |
Onebadx1
| Posted on Saturday, November 07, 2009 - 11:54 am: |
|
They are not LH thread. |
Buellistic
| Posted on Saturday, November 07, 2009 - 12:03 pm: |
|
Use a HAMMER(H-D Tool) and a PUNCH ... Give the SCREW a couple of good raps ... "BUT" not where it will close up the allen wrench hole ... |
Ratbuell
| Posted on Saturday, November 07, 2009 - 12:57 pm: |
|
Also, don't be afraid to shock it *tighter* to try and break it loose. Movement is movement, and if you're pushing it to go tight, you won't round off the tool part of the head in the direction you need it to go in. +50 on heat. |
Sportyeric
| Posted on Saturday, November 07, 2009 - 01:38 pm: |
|
If yours are the same as mine, you can get penetrating oil in from the other side of the wheel. (The hole goes all the way through.) I used most of a can and left it sit for a week. I've got an beaten up old electric impact driver that has almost no torque but I can apply it for a long period until it just annoys a bolt to loosen. |
Adsva83
| Posted on Saturday, November 07, 2009 - 03:31 pm: |
|
Can I expect the same thing on the front wheel and rotor? Those are torx screws and my guess is if it's the same, those will strip easier than the hex bolts do. |
Buellistic
| Posted on Saturday, November 07, 2009 - 03:44 pm: |
|
When "i" remove my rotors, the SCREWS go back in the with "TORQUE'ING COMPOUND" on the threads !!! (Message edited by buellistic on November 07, 2009) |
Onebadx1
| Posted on Saturday, November 07, 2009 - 03:51 pm: |
|
Hate to tell ya.... Mine front sucked way more than the rear. Maybe....? |
Sparky
| Posted on Saturday, November 07, 2009 - 03:59 pm: |
|
These bolts are installed with RED Loctite, so heat from a propane torch must be applied to the bolts before attempting to remove them. |