Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Ezblast
| Posted on Thursday, November 05, 2009 - 02:01 pm: |
|
Rear Sensor Wire Protector - that should be tight/connected to the sensor - right? - Not hanging loose where vibration will sooner or later have the metal wire protector cutting the wires it is meant to protect. EZ |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Xtreme6669
| Posted on Thursday, November 05, 2009 - 11:32 pm: |
|
o2 sensor? |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Ezblast
| Posted on Friday, November 06, 2009 - 12:02 am: |
|
Yes! - Is that guard supposed to be loose on the wire? EZ |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Xtreme6669
| Posted on Friday, November 06, 2009 - 12:07 am: |
|
mine is "loose" on the wire as well but its a pretty light weight heat shield so I really doubt it will wear its way thru the wire insulation... the front is the same way but because the wire in the front doesn't curve as much it sits on there straighter. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Ezblast
| Posted on Friday, November 06, 2009 - 12:12 am: |
|
As long as that is the norm - I guess I'm ok - didn't show it in the service manual, only the parts book - so I wondered if it was compression fitted and just poped off and needed re-fitting. Thanks! EZ |
|