Author |
Message |
Yo_muda
| Posted on Wednesday, September 23, 2009 - 08:00 pm: |
|
How do you check the tranny fluid level in my 02 M2? |
Littlebuggles
| Posted on Thursday, September 24, 2009 - 12:10 am: |
|
Loosen the screws on the clutch inspection/derby cover by only about a half turn to make getting them all loose easier, then back them out (otherwise at least one will round out and you'll have to drill the top off, still not as bad as it sounds). There's a spring under it that keeps pressure against it, it can drop when you remove the cover. Fluid should just be touching the bottom of the clutch assembly with the bike upright (supported by a buddy, 2X4 under the side stand or some other apparatus). |
Littlebuggles
| Posted on Thursday, September 24, 2009 - 12:13 am: |
|
http://www.badweatherbikers.com/buell/Manuals/S1_1 996-1997_Service/BU1b.pdf Use this since we share the sam e tranny as the S1's, pdf page 7. (Message edited by littlebuggles on September 24, 2009) |
Yo_muda
| Posted on Friday, September 25, 2009 - 04:11 pm: |
|
Thank you Littlebuggles. |
Littlebuggles
| Posted on Friday, September 25, 2009 - 07:26 pm: |
|
yup! |
|