Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Kinger
| Posted on Thursday, May 14, 2009 - 10:49 pm: |
|
When the key is placed in the acc. position the odo and speed lights flash. The odometer basically flickers. Recent work: Upgraded charging system to 3-phase Removed clock Installed analog voltage gauge where clock was. I checked the main ground it appears good. The only thing I can think of is that I have open ended power that was too the clock. Any thoughts? Thanks |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Kinger
| Posted on Saturday, May 16, 2009 - 12:34 am: |
|
Update: Paying closer attention tonight... When the key is switched on, the engine light does not come on. The fuel pump also does not come on. I checked voltage at the fuel pump connector. It was 11.4. I disconnected the speed sensor, but I think that needs to be jumpered to bypass it. Any suggestions? |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Kinger
| Posted on Monday, May 18, 2009 - 09:44 am: |
|
Update 2: Followed through most of the procedures for No Check Engine Light in the SM. - Continuity is good on the BL/Y wire from the ECM to the CEL. - I don't appear to have power to the ECM. Used paper clips (no break out box)to check for 12V @ ECM with key on. - ECM has continuity to ground. - I have 11.5V at the ignition relay. - I need to double check IR continuity to ground. If I have continuity to ground on the IR, I think I need ot clean the relay. I am pretty sure I saw an old post by RT on how to do that. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Kinger
| Posted on Tuesday, May 19, 2009 - 09:31 pm: |
|
IR has continuity to ground. The only thing I didn't check from the procedure was a short to the battery on the BL/Y wire between 10 and 39. All signs point to replacing the ECM. Crap............... |
|