Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Buellboiler
| Posted on Sunday, April 05, 2009 - 05:08 pm: |
|
I recently purchased a set of 2000 (slotted) PM wheels and I noticed that the 'spokes' on the rotor carrier (i.e. spider) don't line up with the spokes on the PM wheel. Were these originally installed with the spokes aligned? Also since I plan to remove the carrier are there any tricks to removing the bolts? I remember some noting that they give the fastener a sharp hit to loosen the locktite. Any hints would be appreciated. Boiler |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Zenfrogmaster
| Posted on Sunday, April 05, 2009 - 05:32 pm: |
|
Heat and a hand-held impact driver will help with the bolts (that and a quality Torx or Allen bit - I can't recall which). Use new bolts when reassembling. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Phelan
| Posted on Sunday, April 05, 2009 - 05:32 pm: |
|
Sounds like someone's changed the rotor before. Yeah, the trick is make sure you have the CORRECT size bit (IIRC it's a T-27) and give it good tap with a hammer before attempting to unscrew it. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Buellboiler
| Posted on Sunday, April 05, 2009 - 05:45 pm: |
|
Hmmm, I thought it was strange that the spokes did not line up. Thanks for the quick relies I will check my toolbox the verify the proper torx size. This site is the best!!!! |
|