Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Jettdawg
| Posted on Monday, June 16, 2008 - 06:45 pm: |
|
Does anyone know if this is basically the same as an XB12 air box cover? As in will it fit? I see that the air holes behind the fuel filler aren't there like on a newer XB, but if it's the same other than that (underneath), I guess one could drill the holes in that area (unless the ring around the fuel filler is removeable).
![1125R cover](http://www.badweatherbikers.com/buell/messages/3842/369248.jpg)
|
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Flatliner_dnr
| Posted on Monday, June 16, 2008 - 08:59 pm: |
|
The buell.com site says they're the same thing when it comes to fitment, and everything I've seen on the showroom floor leads me to think that's true. The only diff is the one you've already pointed out I'd say. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Ben782
| Posted on Saturday, June 28, 2008 - 08:31 pm: |
|
If you do swap these, make sure that you install your old screen piece for around the gas cap. If you don't your intake air temp sensor will go bad. It will be reading the wrong "air temp and volume". This is what happened on my xb9sx. It is a pretty easy fix to change the screen piece. Cut off the melted plastic tabs with a razor blade, install the new one and melt over the tabs again to hold it in place. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Vimisasaky
| Posted on Monday, June 10, 2019 - 07:16 am: |
|
The entire details was available at this article at the end of the picture that I got from this blog it was useful among the all part. I have to fetch the data that was about the aussiessayservices.com/ this was the formation that I ah veto read on it along with the parts that was useful for me.}}}}}} |
|