G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile

Author Message   Kurbennett Posted on Wednesday, June 18, 2008 - 04:14 pm:        I bought a new plastic wiring harness/conduit for the wire routing on the front forks. Is there an easy way to remove the old one? There doesnt seem to be enough room for a wrench or torx.   Metalstorm Posted on Wednesday, June 18, 2008 - 04:22 pm:        Try Removing the headlight housing. On my 12S, removing the whole headlight assembly gives me lots of room to get a wrench and an allen wrench in there.   Kurbennett Posted on Wednesday, June 18, 2008 - 09:08 pm:        Thanks Tom, I will look into that. I figured that was a possibility but wasnt sure if removing it would be fairly straight forward.   Metalstorm Posted on Wednesday, June 18, 2008 - 09:14 pm:        It's just a matter of removing the flyscreen, unplugging the headlight housing then two screws (one on either side of the housing) and one screw underneath which I believe also holds up the duckbill on the Uly. I usually use a piece of silver duct tape on the bracket underneath to mark where my housing was set up at so I don't have to go through the aiming process when I put it back on. (Message edited by Metalstorm on June 18, 2008)

Add Your Message Here Post: -Color- Black Red Green Blue Yellow Purple Orange Cyan Gray White -Font- Arial Courier Symbol Times Verdana -Size- Smallest (-2) Small (-1) Normal Large (+1) Largest (+2) Username: Posting Information: This is a private posting area. Only registered users and custodians may post messages here. Password: Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.) Enable HTML code in message Automatically activate URLs in message Action: