Author |
Message |
Gasaxe
| Posted on Friday, April 18, 2008 - 04:54 pm: |
|
My handling isn't as rock steady since my front mount snapped ,and I replaced it with a NRSA mount.The engine dropped, only the front stabilliser and the cylinder hitting the frame arrested it's fall. I now have a slight wag through the bars at speed and when cornering hard on bumpy road surfaces. I can't find any obvious faults to cause this ,any suggestions Lee |
Bad_karma
| Posted on Saturday, April 19, 2008 - 01:13 am: |
|
Lee I'm assuming you also replace the rubber isolator that the mount was attached to. If so Check the swing arm isolators. Next would be a close inspection of the shock and steering head.Also check the lateral stabilizers, three of them I think. Also have a look at rear wheel alignment. But a good rule is to start with the last thing you touched. Joe |
Gasaxe
| Posted on Tuesday, April 22, 2008 - 03:57 pm: |
|
Couldn't find anything wrong with isolators front or back,but did find my rear tyre was down to 32psi instead of 36. The handling is now better,it may be that I am pushing a lot harder in corners as I get used to it's handling. Lee |
|