| Author | Message | |||
     Oldog |
I Was going for the last ride before working over 'olblue this winter, this year the list is short because of whats comming next year after payoff. I found the aft muffler mount broken at the slot edgeslooks like fatuge glad I caught it This years list, Replace or repair Supertrapp rear bracket.  front stearing head bearing check cleanup if needed, reset tension.  brake fluid change front & Rear inspect pads. Plugs, O2 sensor, ET sensor. Inspect wires and boots. Replace head studs, and intake seals at head. inspect rear isos and re grease swing arm bearings. inspect wheel bearings rear wheel. inspect wiring \trying to get low milage sprockets upgrades, turn signals, tail clean up, hid headlight. What are you doing  | |||
| Kyrocket |
Hey Oldog how'd you get your swingarm up on jackstands? Need to pull my rear wheel soon and I think that's probably the way I'll go. I just posted tonight in an earlier thread about making a rear exhaust mount for my SS2R. Crapped out at the bend, not the weld. So far I've... Repacked my muffler. Wrapped my header. Painted the muffler can w/ hi-temp black paint. Replaced the old style primary tension shoe. Replaced the shift shaft seal. Updated the primary gasket. Have all the goodies for an oil change. According to the tracking number the new tires should be here tomorrow so that may open up a whole new can of worms. I'll be checking bearings along with all the other rotating pieces that go along with them. I guess this cold weather is good for something other than cabin fever. | |||
| Guell |
riding and  | |||
| Captainkirk |
Repacked the race muff. Changed oil and primary fluid Wiped off all the bugs from last summer  Consumed malt beverages dreaming of July  | |||
| Oldog |
k-rock: the rear end is supported by the passenger pegs on auto jack stands, get taller ones if you can. Are you going to finish the header wrap thread?? | |||
| 5liter |
Open the garage door periodically to see if it's still in there......... | |||
| Kyrocket |
Yeah, been busy as all get out lately. I have finished the headers, just need to get some pics up and start a part 2. | |||
| Silas_clone |
Trying to replace my isolators. Doing the method described as "easy", but it involves removing swingarm carriage from engine/trans. Went to Fastenal after no luck at HD for the bolts, etc. I want to use new hardware, as recommended. Seems the man at Fastenal is stumped...could I use grade 9? How about socket heads? Here is the parts list. Are grade 12 bolts hard to find?
(Message edited by silas_clone on January 28, 2008) | |||
| Oldog |
Silas Try American Sport Bike | |||
| Silas_clone |
Just spoke with Al He suggested this gizmo Looks like I might give it a try http://www.aeincorporated.com/kastar/?page=show_it em_detail&id=35&qs=cGFnZT1jYXJ0 | |||
| Torquemonster |
Northwest Florida Winter maintenance? Fuel up...Ride out...GRIN! | |||
| Werewulf |
i just keep riding... | |||
| Bad_karma |
S3 Bleed brakes Inspect for loose stuff Lube cables Rejet carb S1 upgrade fork internals replace shock new Avons swing are isolator stiffeners Front cylinder rocker box gaskets Too much for this winter. joe | |||
| Mick |
I'll go riding , too bloody hot in summer. |
