Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Thunderlust
| Posted on Sunday, March 25, 2018 - 08:34 pm: |
|
Someone on BW mentioned tha i need a special socket from Proto to change out the ETS. does anyone know what size socket or Proto part number? Thanks, thunderlust |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Buelliedan
| Posted on Monday, March 26, 2018 - 01:12 pm: |
|
Not a special size but you do need a slot cut in the side to get around the wires. It is just a 1/2" deep socket |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Brother_in_buells
| Posted on Monday, March 26, 2018 - 03:26 pm: |
|
If you have some tube wrenches like this, https://www.ebay.com/itm/Tap-Repair-Spanners-Box-H ex-Square-Tube-Tubular-Socket-Wrench-Plumbing-Tool -/200918683320 then there is no need for a special tool or cutting one up. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Thunderlust
| Posted on Tuesday, March 27, 2018 - 02:00 pm: |
|
There was someone who mentioned that Proto has a socket with the slot cut in it with a part number. Maybe I'll check with Proto. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Akbuell
| Posted on Wednesday, March 28, 2018 - 11:14 am: |
|
Try ironmachine.com. $19.95 for the socket. Or, get a deepwell socket of the correct size from the auto tool section at the grocery store and cut a 1/8" by 1 3/4" long groove in it. When you get in there, don't forget to blow the well out with an air chuck to get debris out before removing the old one. Hope this helps, Dave |
|