Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Russmannnn
| Posted on Thursday, April 11, 2013 - 11:52 am: |
|
Do you need a special tool to pull the rotor once the nut is off? |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Jbarron
| Posted on Thursday, April 11, 2013 - 02:06 pm: |
|
No. It will slide off the splined shaft. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Bartone
| Posted on Tuesday, April 16, 2013 - 01:17 pm: |
|
well.. when I did mine, I needed a rotor puller tool. I used a balancer puller tool that used the same m8 bolts used for holding the sprang clutch. But I was one of the rare people who needed that. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Kruizen
| Posted on Tuesday, April 16, 2013 - 03:44 pm: |
|
I had to use a 3 arm puller from autozone. But I'm in the minority also by the sounds of it. |
|