Author |
Message |
Green1
| Posted on Sunday, December 30, 2012 - 08:13 pm: |
|
I'm looking to change to superbike style handlebars on my 1125R,someone must have done it,what or where did you use for a kit or upper trippletree.I'm not interested in the convertabar setup,i don't like the looks,any other info or links welcome.Thanks |
Tbowdre
| Posted on Sunday, December 30, 2012 - 10:37 pm: |
|
American sport bike has some nice high handlebars that mount in the stock location. What are superbike bars? That makes me think of a clip on that would mount below/ lower than stock. |
Green1
| Posted on Sunday, December 30, 2012 - 11:35 pm: |
|
Superbike bars would be similar to the CR high bar kit |
Tbowdre
| Posted on Monday, December 31, 2012 - 12:08 am: |
|
PM sent |
Zac4mac
| Posted on Monday, December 31, 2012 - 12:13 am: |
|
Sounds like a flat-track bar. I like the bars on Loretta but fine adjust of the angles(down and back) would be nice. Not a whole lot of options for higher unless you cut the fairing some. It's a pretty tight fit if you look close... CR triples should work, but there's that darned key-switch mount... EBR has(or had?) a billet triple set; needs clip-ons, brake/clutch lines, switchgear etc. I ride laid out on the airbox on slab trips. very comfy. I even fell asleep once at 75. The dinosaurs on I-76 woke me up... Z |
Jdugger
| Posted on Monday, December 31, 2012 - 05:46 am: |
|
> Superbike bars would be similar to the CR high bar kit That's a new one for me. (Message edited by jdugger on December 31, 2012) |
Old_guy
| Posted on Monday, December 31, 2012 - 08:28 am: |
|
These.
|
Green1
| Posted on Monday, December 31, 2012 - 05:24 pm: |
|
Yes thats what im after only on an R model,i.ve seen it but so far have been unable to find out who made the the upper tripple clamp with the ignition still in the stock place |
Coastrambler
| Posted on Friday, January 04, 2013 - 03:11 am: |
|
I had a set of handlebars made that bring them about 2" up and back. Much more comfortable for my 6'1" self. Knight Design 2" drop pegs help too. Photo shows first try. Levers were too high due to fluid res clearing riser bar. Second try I put all items 2" farther out on bars. This works great. A little more leverage. Very minimal fairing interference.
|
|