| Author | Message | ||
     Jayvee |
Well, finally found the instruction sheet, never mind! (Message edited by jayvee on December 22, 2012) | ||
| Jayvee |
(Message edited by jayvee on December 22, 2012) | ||
| Jayvee |
(Message edited by jayvee on December 22, 2012) | ||
| Sparky |
Well, now that you've got us hanging, what is the procedure? | ||
| Jayvee |
It says drill out the dimples. Not how, just to do it without drilling into the aluminum under the steel tubing. If you think about it, this would need a concave drill bit.? |
