| Author |
Message |
    
Hacksaw
| | Posted on Thursday, September 22, 2011 - 04:26 pm: | 
|
I relocated my ECM per Rr_eater's method.
I felt there could be some interference with the seat and wiring. I emailed Rr-eater to see what he had done. He urged me to check mine with some play dough and found out there was some interference.
Thanks Bruce for your response.
What I found
ECM Wires Moved
Results
|
Rr_eater
| | Posted on Thursday, September 22, 2011 - 11:59 pm: |
|
Hacksaw
Looks like your ecm is hitting on the plastic "seam" on the battery side, so it will not go "deep" enough into that void. Make sure it is GENTLY down as far as it can go. Look back at my picture, and you can see it is not down as far, the connectors themselves should be at least even if not below the side of the battery there.
Bruce |
Bikelit
| | Posted on Friday, September 23, 2011 - 01:50 am: |
|
Put a shim under the plastic block. |
Hacksaw
| | Posted on Friday, September 23, 2011 - 11:15 am: |
|
Bruce
After gently moving the wires to the right I have clearance. Mine is setting like Billy_bee's in the above picture, setting on top of the left sheet metal battery holder. Yours is further down than either of ours.
Zane |
Slyuly
| | Posted on Friday, September 23, 2011 - 11:19 am: |
|
Moved mine last week and no problems since. |
Hacksaw
| | Posted on Wednesday, September 28, 2011 - 04:22 pm: |
|
Bruce
I got it lower but it sure is tight.
Zane |
|
