Author |
Message |
Bad_boy
| Posted on Saturday, September 25, 2010 - 04:46 pm: |
|
After installing Erik Buell Racing ecm and Barker exhaust I went to set the TPS and its reading system error in all modes' Bike runs wonderful. Any ideas? |
Froggy
| Posted on Saturday, September 25, 2010 - 05:00 pm: |
|
They are historic codes due to the flashing process. Clear them out with ECMspy or by starting the bike 50 times. |
Bad_boy
| Posted on Saturday, September 25, 2010 - 05:31 pm: |
|
how to run ecm spy? |
Badlionsfan
| Posted on Saturday, September 25, 2010 - 06:18 pm: |
|
Just ignore them. After you start the bike 50 times they'll go away, and the only thing they'll effect in the mean time is you so don't look at them. |
Tbowdre
| Posted on Sunday, September 26, 2010 - 02:31 am: |
|
+1... the Erik Buell Racing race calibration is installed/flashed on a bench. so you get all these annoying trouble codes when you go into diagnostic mode. they mean nothing, they do nothing and they will disappear after 50 starts they may actually drive you insane though. wondering if you have in fact started your bike 50 times yet! and what if you have in fact started your bike 50 times and now these are REAL codes.... careful my 0.02 todd |
Xoptimizedrsx
| Posted on Sunday, September 26, 2010 - 02:43 am: |
|
dont use ecmspy (windows version) on 08 up bikes. its not made for them... |
Stimbrell
| Posted on Sunday, September 26, 2010 - 07:39 am: |
|
If you have tunerpro you can set the number of cycles needed to clear codes, in "scalers" you find "number of rides since error set" you could set it to one and then change it back after running the bike. In the stock ecm it is set to 50 but in my Race ecm it came set to 31 so you may find yours clear before 50 cycles. |