Author |
Message |
Edgarr
| Posted on Friday, July 23, 2010 - 03:47 pm: |
|
I have a '99 M2 Cyclone and have got the spring and pin from a '2000. I'm unsure of the correct orientation of the spring. Can someone supply me with a picture or diagram of of the spring. As a point of reference the '99 foot peg had no spring, just a bolt holding the peg on, and mine always seemed to go past vertical whenever I put the side stand up. |
Fuzzy
| Posted on Friday, July 23, 2010 - 10:21 pm: |
|
not stock pegs, but 2000 springs. hope it helps...
|
Edgarr
| Posted on Saturday, July 24, 2010 - 10:18 am: |
|
Helps a bunch. Thanks. |
Jayvee
| Posted on Saturday, July 24, 2010 - 07:57 pm: |
|
Geeminy wilikers, did those peg holders start out as Banke pieces, or did you make them from scratch? That is quite a get-up. Do you have any picture of how the back of the brake pedal connect the the rod coming down from the master cylinder? I'm try to fix mine, the pedal won't adjust low enough for me. (Banke bits...) |
Fuzzy
| Posted on Saturday, July 24, 2010 - 10:29 pm: |
|
they're from scratch
doesn't show much better, but the rod with the cotter pin is drilled and tapped through for the rod from the master cylinder to screw through. same problem here, not enough adjustment in mine either! didn't put enough angle in the pedal itself and it hits the passenger peg mount joint on the frame if you adj it low enough for me.
|
Littlebuggles
| Posted on Tuesday, August 03, 2010 - 03:34 am: |
|
Fuzzy, That's some great looking hardware you've built yourself! |
Fuzzy
| Posted on Tuesday, August 03, 2010 - 10:45 pm: |
|
thanks bugs!
was pretty proud of that bike but sold it last year. still want another tuber but pretty broke and want an 1125 cr too. need to find some more stunters to sell stuff to!
|
|