Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Pabiker
| Posted on Saturday, July 10, 2010 - 12:03 am: |
|
A couple of days ago, my wife and I were riding my '02 S3T, when it got extremely difficult to shift into 5th gear. When I removed the primary chain, clutch basket,etc., I noticed that the detent plate looked strange, so I removed the clip & took it off. The one shift drum pin was sticking out farther than the rest, so I'm going to tap it back in & I was wondering if there is any way to replace the detent with a better system than the little clip that holds it on. Do you have to replace the whole shifter drum? Thanks for any help!}} |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Ft_bstrd
| Posted on Saturday, July 10, 2010 - 09:46 am: |
|
I think there is an after-market solution: http://www.badweatherbikers.com/buell/messages/476 23/577865.html?1278705498 I can't tell if it's just swapping out the screw or if you have to swap out the entire shifter drum. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Bluzm2
| Posted on Saturday, July 10, 2010 - 10:42 am: |
|
Jeff, I've seen that a number of times on different tubers. When possible I've pulled the offending pin(s), cleaned them and the drum hole with carb cleaner then hit them with a THIN film of Locktite Red and tapped them back in the drum. Otherwise I just tapped them back in place. It's been a good fix for all of them. No additional problems. Do not reuse the detent plate clip, they are REALLY cheap and not worth inviting problems.. Brad |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Pabiker
| Posted on Thursday, July 15, 2010 - 06:11 pm: |
|
Thanks so much for your help! I cleaned the offending pin and put a little green loctite on ALL the pins and tapped it back in with a new clip and all seems OK. Hopefully I won't have any more problems with it for at least another 50,000 mi. or so. Thanks again!!! |
|