G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile

Author Message   Cyclonemick Posted on Tuesday, March 30, 2010 - 09:04 am:        I was considering cutting off a large section of My Trans vent hose (that runs underneath tail section of my M2) and running into a catch can which I would mount on the frame somewhere near rear hugger or passenger pegs. Do you think that would effect pressure by shortening hose? I'm doing this just as a precaution so that if I ever blow another Crank Shaft Seal ( I just recently replaced one!) I will not have oil all over my Rear Tire! Any suggestions Welcome!   Drawkward Posted on Tuesday, March 30, 2010 - 11:44 pm:        There's no problem in doing that. It's just a vent hose, no back pressure is gained from having a longer hose. (that's what she said)   4dwuds Posted on Wednesday, March 31, 2010 - 04:33 pm:        I made mine longer and routed it up to the carb area and then put a PCV valve on it. I can see it while riding and can notice any oil accumulation on the breather part of the valve. So far, None.   M2nc Posted on Wednesday, March 31, 2010 - 06:49 pm:        I wrapped the vent tube over the battery and down the right side of it. At the end I wire tied a little clear bottle I can see from the right side of bike. After a ride I can check it and drain if needed.

Add Your Message Here Post: -Color- Black Red Green Blue Yellow Purple Orange Cyan Gray White -Font- Arial Courier Symbol Times Verdana -Size- Smallest (-2) Small (-1) Normal Large (+1) Largest (+2) Username: Posting Information: This is a private posting area. Only registered users and custodians may post messages here. Password: Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.) Enable HTML code in message Automatically activate URLs in message Action: