Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Tq_freak
| Posted on Saturday, September 12, 2009 - 03:44 pm: |
|
The turn signals stopped working on my 12S this week and was trying to figure it out. Well I pulled the pins out of the connector for the flasher to check for corrosion / wire breaks and told my self "don't forget the order" well I did. If some one could just take a snapshot of a diagram of which wire goes where I would be more then appreciative. Side note, I figured it out, the LED flasher went bad. No wire breaks and every circuit has continuity. Flasher stops / Stars working when wiggled . |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Blake
| Posted on Tuesday, September 15, 2009 - 07:01 am: |
|
I had that one nailed from the start. Good you figured it out too. ![: D](http://www.badweatherbikers.com/buell/clipart/biggrin2.gif) |
|