Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Ford92
| Posted on Monday, August 31, 2009 - 11:08 am: |
|
My 99 S3, would only Idle when cold when it stared warming up it would shut off. I tried resetting the TPS with ecmspy I could not get it close to 4.6 degrees before I run out of adjustment? I thing maybe the TPS switch is bad? |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Blake
| Posted on Monday, August 31, 2009 - 01:36 pm: |
|
Switch? There seems to be a lot of confusion about the TPS (throttle position sensor) and the procedure required for a "TPS Reset". If you can describe carefully the procedure that you are following, we may find an error. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Ford92
| Posted on Tuesday, September 01, 2009 - 11:57 am: |
|
Sorry sensor,I tried following ecm spy instructions select Gauges screen and connect to ECM adjusted to 0 plus a little more than it says select the functions tab on ecm spy I could not find anything that says functions tab so I selected diagnostic and punch in select TPS Reset I can change the AFV which reads 100% but cannot do anything with TPS so I went back to gauges screen and from there started from 0 but would only go to about 2 or so and ran out of adjustment? |
|