| Author | Message | ||
     Cmmfiremedic |
Can anyone tell me who makes a stand that will fit the rear of the 1125r. Both ones I have aren't wide enough. | ||
| Thurstonbuell |
American Sportbike has the PitBull Stands that fit | ||
| Thepod |
Here's a cheap alternative http://buelletinboard.com/forums/showthread.php?t= 9413 | ||
| Ron_luning |
If you have an 09 with the swingarm spools, Pit-Bull makes a rear stand for bikes with 240-300mm rear tires that will fit. It's not on their website last time I looked so you have to call them. It is still narrow enough to be usable on my FZ1 with the "standard" (non-spool) swingarm, so you don't have to get rid of it when you get a different bike. | ||
| Endoman33 |
lockhart phillips standard swing arm lift work just fine been using this lift since my m2 bike works on xb's and 1125r | ||
| Bcrawf68 |
I thought about the boards, but they didn't seem stable enough. Wound up using jackstands from my car. the 3 point platforms made the bike stable enough for tire changes. | ||
| Chrisrogers3 |
I use the stands from Harbor freight on my 1125 and they work just fine and at 36 bucks a pop they are a LOT less than the pitbull stands. | ||
| Cmmfiremedic |
which stand are you using from harbor freight. The one that grabs the lift spools or the one that lifts the swing arm. | ||
| Chrisrogers3 |
Go to their website and look up pn 66192 It just barely goes wide enough but it does work perfectly for the swingarm. I haven't tried the front fork adapters yet but they look like they will work out just fine. The other one that grabs the spools is about 4 inches too narrow (found out the hard way). | ||
| Cutty72 |
I have the pit bull stands for my 08 1125. Before I got them, I used my T-Rex stands. They worked except they slid down the swingarm. If you have an 09 with spools, the T-Rex should work for you. |
