Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Buellfart
| Posted on Sunday, January 18, 2009 - 12:06 am: |
|
Just did re jet on 40mm m2 carb, pushed it on intake spigot with rubber boot and the back side appears uneven, out of round just a bit- tried to fix it with a screw driver but it bounces back. Seems to be grabbing both carb and intake spigot from the outside, can't see inside too well- no 3rd arm. Is this normal or should I worry? I installed it several times, always the same. Bracket is on with banjo bolts etc. Don't want intake leak, thanks. Everything went smoothly except this. |
|